Non-Toxic De-Icing Fluid plus BS6580 Corrosion, Scale & Biological Inhibitors – 8704

Available in 25Kg drums

200Kg and IBC orders are POA

Description

Accepta 8704 is a non-toxic, high-efficiency de-icing fluid that incorporates BS6580 proven corrosion, scale and biological inhibitors.

NOTE: This product is no longer available and has been replaced by the following alternative:

Accepta 8700

If you require product selection assistance or technical advice please contact us.

Accepta 8704 can be used across a wide range of applications where a non-toxic de-icer fluid is required.

When there are freezing conditions and rain, sleet and snow there is always a high risk to health and safety. To minimise slip hazards it is essential that platforms, ladders and walkways are kept ice and frost free. This can be effectively and safely achieved using Accepta’s non-toxic de-icing fluid.

Accepta 8704 contains corrosion inhibitors that will protect common metals such as mild and stainless steel, aluminium, copper, brass and cast iron. Accepta 8704 has been tested in accordance with BS5117 and found to meet BS6580 corrosion standards.

Accepta 8704 has been tested and classified as Non-Toxic by an EPA certified laboratory. Previously Propylene Glycol was the only non-toxic glycol based de-icing fluid available, however, this is no longer the case.

Accepta 8704 contains a specially developed additive that prevents it from being metabolised (during digestion) into toxic by-products.

Product mixtures are biodegradable (90% over ten days) and will not remain in the environment or bio-accumulate.

Product Benefits

  • High performance de-icing fluid incorporating corrosion, scale and biological inhibitors
  • Non-toxic de-icer
  • Protects mild and stainless steel, aluminium, copper, brass and cast iron
  • Meets BS6580 corrosion standards
  • Highly versatile, suitable for a wide range of applications
  • Environmentally friendly, product will not remain in the environment or bio-accumulate

Product Properties

Physical state: Liquid, hygroscopic, viscous
Colour: According to specification – indicator may be added (several colours)
Odour: Almost odourless (slightly sweet)
pH (500g/l, 20oC): 6.5 – 8.5
Density (g/cm3): 1 to 1.115 (20oC) depending on inhibitor concentration and dilution

*Full details of the product properties are available in the Safety Data Sheet. See below.

Application & Dosage Information

Accepta 8704 can be diluted with water and is generally applied with hand or power pressurised spraying equipment.

Dilution rates for Accepta 8704 differ to suit ambient conditions e.g. 22% for minus 10oC, 28% for minus 15oC etc.

It is always advisable to carry out a ‘Control Of Substances Hazardous to Health’ (COSHH) assessment before use.

Safety, Storage & Handling

For full details concerning safety precautions, storage and handling procedures for this product please refer to the latest Safety Data Sheet. To request the latest MSDS for this product please fill out the form below.






Additional information

Weight 25 kg