Accepta 2627 is a high performance chloride free scale remover and cleaner.
Accepta 2627 is scientifically formulated from an inhibited blend of phosphoric acid and wetting agents that will readily remove hardness and iron scales in stainless steel plate heat exchangers and plastic moulding units.
Accepta 2627 can be used on any grade of stainless steel since it is chloride free and will not cause corrosion.
- High performance scale remover and cleaner
- Based on inhibited blend of phosphoric acid and wetting agents
- Removes hardness and iron scales
- Suitable for stainless steel plate heat exchangers and plastic moulding units
- Can be used on any grade of stainless steel, chloride free and will not cause corrosion
- Convenient liquid product
|Specific Gravity:||1.10 - 1.20|
*Full details of the product properties are available in the Safety Data Sheet. See below.
Application & Dosage Information
The dosage of Accepta 2627 will vary depending on the amount and type of deposit in the system. It is normally recommended that this product be dosed to give a 20 - 25% solution (as product).
Testing of the acid strength is recommended to ensure that there is enough residual acid present to remove the deposits.
Specific recommendations can be provided by Accepta.
Accepta 2627 should be diluted with water to give a solution of the desired strength. The solution temperature should be kept below 60°C to obtain the best protection from the inhibitors.
The cleaning solutions should be circulated and provisions must be made for venting of gases generated during the cleaning.
Depending on the type of deposit, carbon dioxide and some hydrogen gas may be formed. Open flames should not be allowed in the vicinity of the cleaning due to the potential for hydrogen gas formation.
Once the cleaning is complete the system should be immediately drained, flushed and neutralized with an alkaline product supplied by Accepta.
After recirculating the neutralizing solution, the system should be drained and flushed one final time.
It is always advisable to carry out a 'Control Of Substances Hazardous to Health' (COSHH) assessment before use.
For additional assistance please contact Accepta.
- pH Extech Stick pH meter
- Minilab pH meter + buffers
Material of Compatibility
|MS :||Not recommended|
|PE :||Not recommended|
|PP :||Not recommended|
Safety, Storage & Handling
Accepta 2627 is an acidic solution. Avoid contact with skin, eyes or clothing. If skin comes into contact with product, wash with water. If eyes are affected, flush with water for at least 15 minutes and get medical attention.
For full details concerning safety precautions, storage and handling procedures for Accepta 2627 please refer to the latest Safety Data Sheet. To download the latest safety data for this product use the following link: