Neutralizing Amines & DEAE Boiler Water Condensate Line Treatment – 6307

Available in cases of 4 x 5kg jars

Can be dosed using an Accepta Ultra Feeder Board

Description below


Boiler Water Condensate Treatment

Blended solid concentrate, Accepta 6307 is a proprietary formulation featuring triple component neutralizing amines designed to minimize corrosion in condensate lines by balancing the pH, with the addition of an oxygen corrosion inhibitor. The product active amines are cyclohexylamine, morpholine & (DEHA) diethyl hydroxylamine. Product does NOT conform to FDA Title 21, Section 173 Boiler Water Additives.

Product CANNOT be used in steam that will be in contact with milk and milk products.


Feedrate is dependent upon amount of condensate return and feedwater alkalinity and the amount of oxygen in the condensate. This product should be fed to the boiler or the feedwater.

Dosage Testing Method In Condensate Return
5ppm of product/ppm of O2 pH 7.5 – 9.0
Iron < 1 ppm


The above dosage is an approximate. Testing condensate must be done to verify product is being dosed properly. Adjust product accordingly to control pH and iron in condensate system.

Maximum Solubility: >6.0% @ 27°C / 80°F


Appearance:                Solid – White

Odour:                         characteristic – amine

pH:                               11 – 12


Accepta 6307 should be kept away from acids and oxidising agents in a cool dry area. Properly stored, the product will remain effective for 12 – 18 months. Consult Safety Data Sheet for further information


Accepta 6307 is available in 4.0 kilo containers (4 to a case).


Feed Accepta 6307 using an Accepta board system.

Available in three types:

  • Gravity Fed – No pump needed, requires controller relay or timer
  • Electronic Level Control – Pump needed
  • Mechanical – Pump needed

It is always advisable to carry out a ‘Control Of Substances Hazardous to Health’ (COSHH) assessment before use.

For further technical assistance concerning Accepta 6307 please contact Accepta.

Dissolving Data

This chart shows the Accepta Feeder reservoir solution strength of our bottle and disc products based on solution conductivity. Chart Data was generated with DI water, so make up water conductivity needs to be considered in field conditions.

Safety, Storage & Handling

For full details concerning safety precautions, storage and handling procedures for this product please refer to the latest Safety Data Sheet. To request the latest MSDS for this product please fill out the form below.

    Additional information

    Weight 25 kg