Very High Molecular Weight Cationic Acrylamide Co-Polymer in a Hydrocarbon Emulsion – 4543

Available in 25Kg drums

200Kg and IBC orders are POA


Accepta 4543 is a high performance, very high molecular weight cationic acrylamide co-polymer in a hydrocarbon based emulsion.

Accepta 4543 is a very versatile product and has numerous applications, it is especially useful for use in streams where phase separation takes place by decantation or flotation.

Accepta 4543 demonstrates excellent results and performance when used in sludge dewatering processes, especially when this is carried out by centrifugation.

Accepta 4543 has a high actives content making it an ideal choice for applications where the flocculant demand is significant.

Accepta 4543 can work alone or can be combined with other common products used in water treatments as: aluminium chloride, aluminium polychloride, ferric chloride, polyamine, lime, etc. Under such circumstances if an anionic flocculant is used during the final stages a more complete and effective flocculation (dual treatment) can be achieved.

Accepta 4543 is effective across a wide pH range, it is also easy to handle, and dissolves readily in use.

Product Benefits

  • High performance very high molecular weight cationic acrylamide co-polymer
  • Ideal for wastewater treatment and sludge dewatering applications, especially when this is carried out by centrifugation
  • Highly versatile, can be used across a wide range of applications
  • Good where phase separation takes place by decantation or flotation
  • Can be used alone or with other treatment formulations
  • Effective across a wide pH range
  • Easy to handle, and dissolves readily

Product Properties

Form: Cationic acrylamide co-polymer in hydrocarbon based emulsion
Appearance: White clear viscous liquid
Density: 1.03 – 1.05 g/cm³
pH: N/A
Viscosity: 300 – 1000 cp
Viscosity (at %): 1.0% 350 – 500 cp
Ionic Character: Cationic
Ionicity: Low
Molecular weight: Very high

*Full details of the product properties are available in the Safety Data Sheet. See below.

Application & Dosage Information

Accepta 4543 must be dissolved in water prior to its use in the application at a concentration between 0.5 – 1.0% of product. Dissolution will occur rapidly if conditions are good. Strong agitation (over 500 rpm) of the solution is highly recommended.

For effective and rapid dissolution to take place it is important to get a good first contact between Accepta 4543 and water. We recommend pouring Accepta 4543 slowly over strongly agitated water. A small dose of product should contact water on the vortex formed by the agitation. Continue to thoroughly mix until all the product has been fed into the water, after that the agitation rate may be reduced till the dissolution is complete.

Solutions with concentrations above 2% should not be used.

Solution stability depends on several factors: quality of the dilution water (hardness, conductivity, and pH), temperature, concentration, etc. We recommended using any prepared dissolution within a few hours after its preparation. When a loss of viscosity is observed it usually means that the prepared solution has degraded. If this occurs the dissolution is still useful, though the dosage necessary to maintain product performance may be higher.

If required, the solution can be filtered through a 250 micron screen to remove small particles that have not dissolved.

It is always advisable to carry out a ‘Control Of Substances Hazardous to Health’ (COSHH) assessment before use.

Safety, Storage & Handling

For full details concerning safety precautions, storage and handling procedures for this product please refer to the latest Safety Data Sheet. To request the latest MSDS for this product please fill out the form below.

    Additional information

    Weight 25 kg