Scale Remover & Cleaner (Hardness / Iron Scales) – Kintec 5002

Available in 25Kg drums

 

Description

Kintec 5002 is a high-performance chloride free scale remover and cleaner.

Kintec 5002 is scientifically formulated from an inhibited blend of phosphoric acid and wetting agents that will readily remove hardness and iron scales in stainless steel plate heat exchangers and plastic moulding units.

Kintec 5002 can be used on any grade of stainless steel since it is chloride free and will not cause corrosion.

Product Benefits

  • High performance scale remover and cleaner
  • Based on inhibited blend of phosphoric acid and wetting agents
  • Removes hardness and iron scales
  • Suitable for stainless steel plate heat exchangers and plastic moulding units
  • Can be used on any grade of stainless steel, chloride free and will not cause corrosion
  • Convenient liquid product

Product Properties

Form: Liquid
Colour: Clear, colourless
pH: < 1.0
Specific Gravity: 1.10 – 1.20

*Full details of the product properties are available in the Safety Data Sheet. See below.

Application & Dosage Information

The dosage of Kintec 5002 will vary depending on the amount and type of deposit in the system. It is normally recommended that this product is dosed to give a 20 – 25% solution (as product).

Testing of the acid strength is recommended to ensure that there is enough residual acid present to remove the deposits.

Specific recommendations can be provided by Accepta.

Dosage Strategy

Kintec 5002 should be diluted with water to give a solution of the desired strength. The solution temperature should be kept below 60°C to obtain the best protection from the inhibitors.

The cleaning solutions should be circulated and provisions must be made for venting of gases generated during the cleaning.

Depending on the type of deposit, carbon dioxide and some hydrogen gas may be formed. Open flames should not be allowed in the vicinity of the cleaning due to the potential for hydrogen gas formation.

Once the cleaning is complete the system should be immediately drained, flushed and neutralized with an alkaline product supplied by Accepta.

After recirculating the neutralizing solution, the system should be drained and flushed one final time.

It is always advisable to carry out a ‘Control Of Substances Hazardous to Health’ (COSHH) assessment before use.

For additional assistance please contact Accepta.

Test Methods

  • pH Extech Stick pH meter
  • Minilab pH meter + buffers

Material of Compatibility

Material Comments
SS : Acceptable
MS : Not recommended
PE : Not recommended
PP : Not recommended
PVC : Acceptable
Teflon : Recommended

Safety, Storage & Handling

For full details concerning safety precautions, storage and handling procedures for this product please refer to the latest Safety Data Sheet. To request the latest MSDS for this product please fill out the form below.






Additional information

Weight 25 kg